Kenmore 26-20232 Uživatelský manuál stáhnout pdf (Strana 4)

CONTROL PANEL AND FEATURES

WATER LEVEL

Set the Water Level knob to the Auto Sensing setting and the

washer will ll to a level that ensures the load engages the

agitator. From this point, the electronic control will sense the

load and determine if additional water is needed.

Set the Water Level knob to the Deep Fill setting and the

washer will ll to the maximum water level. This option is not

available on Normal wash cycles.

NOTE: Expect longer wash cycle times due to extended ll

times when using the Deep Fill option.

WASH TEMP

Wash Temp senses and maintains uniform water temperatures

by regulating incoming hot and cold water.

Select a wash temperature based on the type of fabric and

soils being washed. For best results and following the garment

label instructions, use the warmest wash water safe for your

fabric.

• On some models and cycles, warm and hot water may be

cooler than your previous washer.

• Even in a cold and cool water wash, some warm

water may be added to the washer to maintain

a minimum temperature. All rinses are cold.

WASH CYCLE KNOB

Use the Wash Cycle knob to select cycles on your washer.

See “Cycle Guide” for detailed descriptions of cycles.

START/PAUSE/UNLOCK LID BUTTON

Press to start the selected cycle; press again to pause the

cycle and unlock the lid.

NOTE: If the washer is spinning, it may take several minutes to

unlock the lid. Press and hold for 3 seconds to cancel a cycle.

CYCLE STATUS INDICATOR LIGHTS

The Cycle Status Lights show the progress of a cycle. At each

stage of the process, you may notice sounds or pauses that

are dierent from traditional washers.

SENSING

When the Start/Pause button is pressed, the washer will ll

and begin sensing to determine the load size.

Once sensing is complete, the washer will ll to the

detected load size and then begin the wash phase of the

cycle.

NOTE: Sensing ll and agitation phases will be paused by

opening the unlocked lid. Close the lid to resume the cycle.

If the lid is left open for more than 10 minutes the washer

will cancel the cycle and pump out the water. The lid will

lock after the wash phase to begin the initial spin and

remain locked for the remainder of the cycle.

WASH

You will hear the motor and agitator moving the load.

During the rst stage of the sensing/wash cycle, water will

partially ll the washer and then begin to move the load. It

is normal to have the sensing light on during this stage. You

will hear the agitator rotate, followed by a several second

pause. This process will repeat for several minutes, allowing

the entire load to become saturated. The lower water

level combined with HE detergent at this stage allows for

concentrated cleaning. Concentrated cleaning delivers the

detergent directly to the soils. It is normal for the load to

be above the water line during this stage. At the beginning

of the second stage, the washer will add water to the

correct level based on the load size. You will hear the

agitator move quicker during this stage of the wash cycle.

The motor sounds may change at dierent stages in the

wash cycle.

2 3

Not all features and options are available on all models.

Appearance may vary.

1 2 3 4 5 6 7 8 9 ... 55 56

Komentáře k této Příručce

Žádné komentáře

Kenmore 26-20232 Uživatelský manuál Strana 4

Komentáře k této Příručce